Undo

What it Does

Goes back one step in your draft. A draft is one pattern project. Each time you save a tool, PMP keeps that moment as a version, like a saved step. The version number is shown at the top of the toolbox.

Undo loads the version before the one you are on. You can keep using it to go back to the first version.

Use this when you saved a step you did not want.

How to Use

1. Select File > Undo from the main menu
2. The workspace reloads the previous version, and the version number at the top of the toolbox goes down by one
3. Select File > Undo again to go back another step

If you are already on version 1, a message says "No prior version available."

warning

The version you step back from is deleted, along with any memorized commands saved for it. You cannot get it back.

info

Export PDF also uses Undo behind the scenes. It saves a version to make the PDF and then steps back, so your version number stays the same.