Skip to main content

Edit Measurement Set

What it Does​

Changes a measurement set you already saved. You can add, change or remove measurements, rename the set, or delete the set.

A measurement set is a named list of body measurements, for one person or for one size. See Add Measurement Set to create one.

Use this when a measurement was typed wrong, when you need to add a missing measurement, or when you no longer need a set.

The values in a set are stored in the unit you chose when you created the set. You cannot change that unit here. Always type values in the unit shown next to the Value box.

warning

After you change a value in the list, select Actions > Update. The change is not saved until you do.

How to Use​

  1. Select Measurements > Edit Measurement Set from the main menu. If you have no sets yet, the toolbox says "No measurement sets available." Create one first.
  2. Select a set from the Available Sets: list.
  3. Select what you want to do. Add/Edit Measurements is selected to start with.
    • Add/Edit Measurements shows the measurements in the set.
    • Change Set Name renames the set.
    • Delete Set removes the set and all of its measurements.
  4. Select Continue.

Add/Edit Measurements​

  1. Start typing a measurement name in the Name box. A list of common measurement names appears. Select one from the list, or keep typing to use your own name.
  2. Type the measurement in the Value box. Use the unit shown to the right of the box, not the unit of your draft. Type a plain number. Formulas do not work here.
  3. Select Save New. The measurement appears in the list at the bottom of the toolbox.
  4. To change a value, type the new number in its box in the list, select Actions, and then select Update.
  5. To remove a measurement, select Actions > Delete. It is removed right away.
  6. Select Close when you are done.

Change Set Name​

  1. Type the new name in the New Name: box. The old name is shown above it for reference.
  2. Select Save. PMP shows a message with the old and new names.
  3. Select Close.

Delete Set​

  1. Read the warning. Deleting removes the set and all of its measurements, and it cannot be undone.
  2. Select Delete to confirm, or Cancel to keep the set. PMP shows a message when the set is deleted.
  3. Select Close.
info

If you edit the set that is currently loaded for your draft, PMP updates the loaded values for you. See Load Set for Active Draft.

tip

Sets are included in your Backup Data backups. Back up before you delete a set you might want again.

info

A set cannot be renamed to an empty name or to a name another set already has. If the set is loaded for the draft you are working on, renaming it keeps it loaded under the new name, and deleting it unloads it, so the toolbox shows None Selected. A value must be a number when you select Update.